No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Principles

Principles

This section describes only the differences between IS-IS for IPv6 and IS-IS. For details about the IS-IS implementation principles, see Principles.

IS-IS IPv6

IS-IS is a link-state dynamic routing protocol initially designed by the OSI. To support IPv4 routing, IS-IS is applied to IPv4 networks and called as Integrated IS-IS.

As IPv6 networks are built, IS-IS also needs to provide accurate routing information for IPv6 packet forwarding. IS-IS has good scalability, supports IPv6 network layer protocols, and is capable of discovering, generating, and forwarding IPv6 routes.

Extended IS-IS for IPv6 is defined in the draft-ietf-isis-ipv6-05 of the IETF. To process and calculate IPv6 routes, IS-IS uses two new TLVs and one network layer protocol identifier (NLPID).

The two TLVs are as follows:

  • TLV 236 (IPv6 Reachability): describes network reachability by defining the route prefix and metric.

  • TLV 232 (IPv6 Interface Address): is similar to the IP Interface Address TLV of IPv4, except that it changes a 32-bit IPv4 address to a 128-bit IPv6 address.

The NLPID is an 8-bit field that identifies the protocol packets of the network layer. The NLPID of IPv6 is 142 (0x8E). If IS-IS supports IPv6, it advertises routing information through the NLPID value.

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 60617

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next