No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Introduction to RIP

Introduction to RIP

This section describes the definition and purpose of RIP.

Definition

Routing Information Protocol (RIP) is a simple Interior Gateway Protocol (IGP). RIP is a Distance-Vector protocol that uses hot count to measure the distance between the local device and the destination. RIP exchanges routing information using UDP packets on UDP port 520.

Two versions are available for RIP: RIP-1 and RIP-2. RIP-2 is an extension to RIP-1.

Purpose

RIP is easy to implement, and is easier to configure and manage than OSPF and IS-IS. Therefore, RIP is applicable to small-sized networks, such as campus networks and simple LANs. It is not suitable for complex environments or large-sized networks.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 59204

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next