No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Splitting a Stack

Splitting a Stack

This section describes how to split a stack.

Context

If a stack is not required, split the stack to restore the member switches to standalone switches. The recommended procedure for splitting a stack is as follows:
  1. Back up the stack configuration file in case the stack will be used again.

  2. Remove stack cables.

  3. Restore the physical member ports as service ports.

  4. Restore the stack member ID to the default value.

  5. Restart the switches.

Procedure

  1. Run the save command in the user view to save the configuration.
  2. Run the copy source-filename destination-filename all command to back up the configuration file to all the member switches.
  3. Remove stack cables between the member switches.
  4. Delete the physical member ports from the stack ports using either of the following methods:

    • Run the undo port member-group interface interface-type { interface-number1 [ to interface-number2 ] } &<1-16> command in the stack port view.

    • Run the undo stack-port [ member-id/port-id ] command in the interface view.

  5. Restore the physical member ports as service ports using either of the following methods:

    • Run the undo port mode stack interface interface-type { interface-number1 [ to interface-number2 ] } &<1-16> command in the stack port view.

    • Run the undo port mode stack command in the interface view.

  6. Run the stack member member-id renumber new-member-id command in the stack management view to restore the stack member ID to the slot number.
  7. Run the save command in the user view to save the configuration.
  8. Run the reboot command in the user view to restart the switch.

    Perform steps 4 to 8 on each member switch.

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 60722

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next