No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Storm Control

Configuring Storm Control

Storm control prevents broadcast storms and ensures device forwarding performance.

Context

To limit the rate of incoming broadcast packets, multicast packets, and unknown unicast packets and prevent heavy traffic on a device, configure storm control on an interface.

Pre-configuration Tasks

Before configuring the storm control function, complete the following task:
  • Configuring link layer protocol parameters for interfaces to ensure that the link layer protocol status on the interfaces is Up

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    storm control { broadcast | multicast | unicast } max-rate max-rate-value

    Storm control is performed on broadcast packets, multicast packets, or unknown unicast packets on the interface.

    NOTE:

    After the storm control unicast max-rate max-rate-value command is executed, the device suppresses the known unicast packets.

  4. Run:

    storm control action error-down

    The command sets the storm control action to shutdown.

  5. (Optional) Run:

    storm control enable { log | trap }

    The function of recording logs or reporting traps during storm control is enabled.

  6. (Optional) Run:

    storm control interval interval-value

    The detection interval is set.

  7. Run:

    commit

    The configuration is committed.

Checking the Configuration

Run the display storm control [ interface interface-type interface-number ] command to check the storm control configuration on the interface.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 59291

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next