No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

The device supports the following BFD features: BFD session setup, BFD detection mode, single-hop and multi-hop BFD, static BFD with automatically negotiated discriminators, VPN route detection and dynamic change of BFD parameters.

Table 11-10 describes the BFD configuration tasks.

Table 11-10 BFD configuration task summary




Configure single-hop BFD

Single-hop BFD fast detects faults on the directly connected link.

Configuring Single-Hop BFD

Configure multi-hop BFD

Multi-hop BFD fast detects faults on the indirectly connected link.

Configuring Multi-Hop BFD

Configure static BFD with automatically negotiated discriminators

When the peer device uses dynamic BFD and the local device wants to communicate with the peer device and detect static routes, create a BFD session with automatically negotiated discriminators. This function is mainly used in scenarios where static routes are used to implement Layer 3 connectivity.

Configuring Static BFD with Automatically Negotiated Discriminators

Configuring BFD to Detect VPN Routes

BFD fast detects faults on the VPN routes.

Configuring BFD to Detect VPN Routes

Configure BFD association

Association between BFD and other protocols improves upper-layer application performance and fast detects faults on links.

Configuring BFD Association

Adjust BFD parameters

You can adjust BFD parameters so that the BFD session can fast detect faults on links.

Adjusting BFD Parameters

Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 61121

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next