No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Uplink and Downlink Interfaces in a Monitor Link Group

Configuring Uplink and Downlink Interfaces in a Monitor Link Group

This section describes how to create a Monitor Link group, configure uplink and downlink interfaces, and enable revertive switching.

Context

An interface cannot be added to a Monitor Link group in the following situations:
  • The interface has been added to a Smart Link group.
  • The interface has been added to another Monitor Link group.
  • A stack port

A Monitor Link group consists of at most 16 uplink interfaces and 64 downlink interfaces.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    monitor-link group group-id

    The Monitor Link group view is displayed.

    The device supports a maximum of 24 Monitor Link groups.

  3. Run:

    port interface-type interface-number { downlink [ downlink-id ] | uplink }

    An interface is configured as the uplink or downlink interface of the Monitor Link group.

    Or, run:

    smart-link group group-id uplink

    The Smart Link group is configured as the uplink of the Monitor Link group.

  4. (Optional) Run:

    timer recover-time recover-time

    The wait to restore (WTR) time is set.

    By default, revertive switching of a Monitor Link group is enabled and the default WTR time is 3 seconds.

  5. Run:

    commit

    The configuration is committed.

Checking the Configuration

  • Run the display monitor-link group { all | group-id } command to check information about a Monitor Link group.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 57182

Downloads: 3617

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next