No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring DCBX

Configuring DCBX

DCB allows DCB devices at both ends of a link to discover and exchange DCB configurations.

Pre-configuration Tasks

Before configuring DCBX, complete the following task:
  • Configuring a link layer protocol so that interfaces at both ends of a link are Up

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    lldp enable

    The Link Layer Discovery Protocol (LLDP) is enabled globally.

  3. Run:

    interface interface-type interface-number

    The interface view is displayed.

  4. Run:

    lldp tlv-enable dcbx

    The interface is configured to advertise DCBX TLVs.

  5. (Optional) Run:

    dcb compliance intel-oui

    The version number in the outgoing DCBX TLV is set.

    Two standards are available for the Data Center Bridging eXchange (DCBX) protocol: IEEE DCBX and Intel DCBX.

    By default, an interface sends DCBX TLVs of the IEEE standard version.

  6. Run:

    commit

    The configuration is committed.

Checking the Configuration

Run the display lldp tlv-config [ interface interface-type interface-number ] command to check TLV types supported by the system or an interface.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 58978

Downloads: 3621

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next