No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings

Default Settings

This section describes default parameter settings of link aggregation.

Table 5-10 Default parameter settings of link aggregation

Parameter

Value

Link aggregation mode

Manual load balancing mode

max active-linknumber

8 on the CX111&CX915 switch module GE switching plane and 16 on the others.

least active-linknumber

1

LACP system priority

32768

LACP port priority

32768

LACP preemption

Disabled

LACP preemption delay

30s

Timeout interval at which LACPDUs are received

90s

Function that preferentially forwards local interface traffic on an Eth-Trunk

Enabled

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 60571

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next