No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

The device supports the manual load balancing mode and Link Aggregation Control Protocol (LACP) mode. In a stack, local traffic is first forwarded by the Eth-Trunk.

Table 5-9 lists the configuration task summary of Link Aggregation.

Table 5-9 Configuration task summary of Link Aggregation
Item Description Task

Configuring Link Aggregation in Manual Load Balancing Mode

In manual load balancing mode, you must manually create an Eth-Trunk and add member interfaces into the Eth-Trunk. All active links forward data and evenly load balance traffic. The manual load balancing mode mode is used when the peer device does not support LACP.

Configuring Link Aggregation in Manual Load Balancing Mode

Configuring Link Aggregation in LACP Mode

In LACP mode, you must manually create an Eth-Trunk and add interfaces to the Eth-Trunk. LACP determines active interfaces by negotiating parameters through LACPDUs. LACP has backup links and ensure high reliability of the member links

Configuring Link Aggregation in LACP Mode

Configuring Forwarding Through Local Member Interfaces (in a stack)

On a network where the stack and Eth-Trunk are used, configure the Eth-Trunk to preferentially forward local interface traffic to increase bandwidth use efficiency between stack devices and improves traffic forwarding efficiency.

Configuring Forwarding Through Local Member Interfaces (in a Stack)

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 78720

Downloads: 3636

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next