No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Environment

Application Environment

This section describes the applicable environment of MSTP.

Application of MSTP

Figure 5-116 Networking diagram for a typical MSTP application

MSTP allows packets in different VLANs to be forwarded by using different spanning tree instances, as shown in Figure 5-116. The configurations are as follows:

  • All devices on the network belong to the same MST region.

  • VLAN 10 packets are forwarded within MSTI 1; VLAN 30 packets are forwarded within MSTI 3; VLAN 40 packets are forwarded within MSTI 4; VLAN 20 packets are forwarded within MSTI 0.

In Figure 5-116, S1 and S2 are devices at the aggregation layer; S3 and S4 are devices at the access layer. Traffic from VLAN 10 and VLAN 30 is terminated by aggregation devices, and traffic from VLAN 40 is terminated by the access device. Therefore, S1 and S2 can be configured as the roots of MSTI 1 and MSTI 3, and S3 can be configured as the root of MSTI 4.

Application of MSTP Multi-process

As shown in Figure 5-117, the UPEs are connected to each other through Layer 2 links and enabled with MSTP. The rings connected to the UPEs must be independent of each other. The devices on the rings connected to the UPEs support only RSTP, not MSTP.

After MSTP multi-process is enabled, each MSTP process corresponds to a ring connected to the UPE. The spanning tree protocol on each ring calculates a tree independently.

Figure 5-117 Application with both MSTP and STP/RSTP

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 61161

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next