Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a 60 W Independent Power Module
Context
To avoid electric shock, do not connect power cables while the power is on.
Make sure the following prerequisites are met before the installation:
- The DIN rail has been secured in position.
- The 60 W AC power module is placed near the DIN rail for convenient movement.
Procedure
- Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact with your wrist.
- Mount the DIN mounting kit onto the rear panel of the 60 W AC power module with M3 screws, and then use a Phillips screwdriver to tighten the M3 screws.
- Place the rear panel of the 60 W AC power module in front of the DIN rail and ensure that the DIN rail fits in between the fixture near the top of the DIN mounting kit and spring latch near the bottom.
- Make the power module incline forward with the bottom away from the DIN rail, and place the fixture at the rear of the DIN mounting kit on the top of the DIN rail.
- Slowly push the power module toward the DIN rail to make the spring latch near the bottom of the DIN mounting kit move down. The spring latch then bounces back to fix the power module on the DIN rail.
If the spring latch is too tight to move down, you can pull down the spring latch during the installation.
