Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Scenario: Desk Mounting
Context
This installation method applies to all switch models except the S5710-HI, S6700-EI, and S6720-HI.
Follow these precautions:
- Ensure that the desk is flat, sturdy, and properly grounded.
- Leave at least 50 mm (2.0 in.) clearance around the switch for heat dissipation. Do not install a switch with its air intake vent facing or close to the air exhaust vent of other devices.
- Do not place any objects on the switch.
Tools and Accessories
- ESD wrist strap or ESD gloves
- Rubber pads (four per switch)
- Security lock (optional, purchased separately)
No rubber pads are delivered with a switch that does not support desk mounting.
Procedure
- Wear an ESD wrist strap or ESD gloves. When wearing an ESD wrist strap, ensure that it is in close contact with your wrist and grounded properly.
- Attach the rubber pads to the imprinted round areas at the bottom of the switch. See a in Figure 3-17.
- Place the switch gently on the desk. See b in Figure 3-17.
- (Optional) Install a security lock to lock the switch to the desk. See c in Figure 3-17.
To determine whether a security lock can be installed, check for the security slot marked with a padlock icon on the chassis. See Figure 3-18. If there is no security slot on the switch, it means that the security lock is not supported.
The security slot is 7 mm long and 3 mm wide. The maximum radius of its four round corners is 1 mm.
