Unpacking a Switch
Context
A switch and its cables, cards, and power modules usually ship in cartons. This section describes how to unpack a 442.0 mm x 220.0 mm x 43.6 mm (17.4 in. x 8.7 in. x 1.72 in.) switch model. The methods for unpacking switch models of other dimensions or other components are similar.
- Before opening the package, check whether the seal label or package is damaged. If there are signs of damage, stop unpacking and contact the supplier.
- Moving an unpacked switch over a long distance may damage the switch. Do not unpack the switch until you are ready to begin installation.
- Save the carton and packing material in case of future transportation.
Procedure
- Wear protective gloves to protect your hands.
- Check the label on the carton to confirm whether the switch
model is correct.
- Use a utility knife to cut the adhesive tape around the
cover of the carton.
- Open the carton and take out the installation accessory
package and the Quick Start Guide package.
The Quick Start Guide manual may be included in the installation accessory package or packaged independently.
- Take the switch out of the carton and remove the foam packing
materials.
- Take the switch out of the ESD bag and check switch surfaces
and the warranty seal on the switch. If the switch is found eroded
or damp or if the warranty seal is damaged, stop unpacking and contact
the supplier.
Huawei is unable to provide warranty services if the warranty seal is damaged or removed.
- Check whether the nameplate on the chassis is consistent with the label on the carton. The nameplate is attached to either the top or bottom of the chassis.
Follow-up Procedure
Save the installation accessory package for later use. The installation accessory package contains the following items: ground cable, mounting brackets, screws, rubber pads, dust plugs, Phoenix connectors, and the Open Source Software Notice. The Quick Start Guide package also contains the warranty card.