No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX210 Switch Module V100R001 User Guide 14

This document describes the CX210 multi-plane switch module of the E9000 server in terms of its features, installation, removal, and configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Preparing for the Configuration

Preparing for the Configuration

This topic describes preparations for configuring and connecting the MX210 to the fabric network and storage array.

Before configuring and connecting the MX210 to the fabric network and storage array, perform the following tasks:

  • Make sure that the CX210 has been installed and powered on.
  • Access the SFTP server and back up MX210 configuration information.
  • If the DHCP mode is not used, obtain an available IP address as well as the related subnet mask and gateway address first.
  • If no MM910 or CLI can be used to change the MX210 IP address, prepare a computer as a management workstation. Make sure that the workstation supports virtual terminals (such as HyperTerminal) or KVM devices. Use a serial cable to connect the workstation to the SYS serial port of the CX210.
Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000053379

Views: 22144

Downloads: 618

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next