No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei Rack Server iBMC Alarm Handling 27

This document describes iBMC alarms in terms of the meaning, impact on the system, possible causes, and handling suggestions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-0x02000027 Hard Disk Status Abnormal (Disk, Minor Alarm)

ALM-0x02000027 Hard Disk Status Abnormal (Disk, Minor Alarm)

Description

Alarm message:

The [arg1] disk arg2 state is abnormal (SN: arg3, PN: arg4).
NOTE:

From iBMC V316, the CPU and disk alarms will also include the SN and part umber and the mainboard and memory alarms will also include the part number.

This alarm is generated when an abnormal hard disk status is detected.

NOTE:
If arg2 is DISKA, DISKB, DISKC, or DISKD, this alarm is generated for the rear hard disk of a V2 or V3 server. For details about the slot information of the hard disks on a V3 server, see "Removing a Hard Disk" in the user guide of the server you use.

Alarm object: disk

NOTE:

This alarm also applies to SATADOM and M.2 disks.

Attribute

Alarm ID Alarm Severity Auto Clear

0x02000027

Minor

Yes

Parameters

Name Meaning
arg1

Location of the hard disk. For example, FM or CMn.

arg2

Slot number of the hard disk.

arg3

Disk serial number.

arg4

Part number.

Impact on the System

Services related to the faulty hard disk are affected, and data is lost.

Possible Causes

  • Improper operation was performed on the hard disk or RAID controller card.
  • The hard disk is faulty.

Procedure

  1. Check for and clear the hard disk fault alarm.
  2. Change the hard disk firmware status to UNCONFIGURED GOOD or OFFLINE. Then, check whether the alarm is cleared.

    To check the hard disk status, log in to the iBMC WebUI, choose Information > System Info > Storage, select the Configure tab, and change the hard disk firmware status.

    • If yes, go to 3.

    • If no, go to 4.

  3. Replace the hard disk. Then, check whether the alarm is cleared.

    For details about how to replace a hard disk, see the user guide.

    • If yes, no further action is required.

    • If no, go to 4.

  4. Contact Huawei technical support.
Download
Updated: 2019-02-28

Document ID: EDOC1000054724

Views: 216416

Downloads: 2918

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next