No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S1720, S2700, S3700, S5700, S6700, S7700, and S9700 Series Switches Common Operation Guide

This document describes the CLI-based configurations of universal protocols and common features for Huawei switches on basic networks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Stack Ports

Configuring Stack Ports

Configuring stack ports is to configure service ports as stack member ports for service port stacking.

For example, configure XGE0/0/1 as a stack member port.

Versions later than V200R002

<HUAWEI> system-view
[HUAWEI] interface stack-port 0/1  
[HUAWEI-stack-port0/1] port interface xgigabitethernet 0/0/1 enable  //Add XGE0/0/1 to the stack port to make XGE0/0/1 become a stack member port. Multiple service ports can be added to a stack port at a time.
Warning: Enabling stack function may cause configuration loss on the interface. Continue? [Y/N]:y 
Info: This operation may take a few seconds. Please wait....... 

V200R002 and earlier versions

<HUAWEI> system-view
[HUAWEI] stack port interface xgigabitethernet 0/0/1 enable  //Configure XGE0/0/1 as a stack port.
Warning: This operation will clear all configurations on these interfaces, continue? [Y/N]:y                                        
Info: This operation may take a few seconds. Please wait for a moment...
[HUAWEI] interface stack-port 0/1  
[HUAWEI-stack-port0/1] port member-group interface xgigabitethernet 0/0/1  //Add XGE0/0/1 to the specified stack port.
NOTE:
  • A switch has a total of two stack ports, Stack-Portn/1 and Stack-Portn/2, where n indicates the stack ID of the switch.
  • A stack member port supports only stack-related functions and other functions are unavailable on the port. All the commands irrelevant to the stack function are masked in the interface view, and only basic configuration commands, such as description (interface view), are retained.
Translation
Download
Updated: 2018-09-03

Document ID: EDOC1000057410

Views: 90055

Downloads: 12204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next