No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S1720, S2700, S3700, S5700, S6700, S7700, and S9700 Series Switches Common Operation Guide

This document describes the CLI-based configurations of universal protocols and common features for Huawei switches on basic networks.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Port Group

Configuring a Port Group

Configuring a Temporary Port Group

# Run the port-group group-member command to add GE1/0/9 to GE1/0/15 to a temporary port group.
<HUAWEI> system-view
[HUAWEI] port-group group-member gigabitethernet 1/0/9 to gigabitethernet 1/0/15
# Run the interface range command to add GE1/0/16 to GE1/0/20 to a temporary port group. (The interface range command is supported by only V200R003C00 and later versions.)
<HUAWEI> system-view
[HUAWEI] interface range gigabitethernet 1/0/16 to gigabitethernet 1/0/20

Configuring a Permanent Port Group

# Run the port-group command to add GE1/0/1 to GE1/0/8 to permanent port group portgroup1.
<HUAWEI> system-view
[HUAWEI] port-group portgroup1
[HUAWEI-port-group-portgroup1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/8

Related Content


Configure Switch Ports in a Batch.

Updated: 2018-09-03

Document ID: EDOC1000057410

Views: 122226

Downloads: 13172

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next