No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro E9000 Server iBMC (Earlier Than V250) User Guide 31

This document describes the underlying management software Intelligent Baseboard Management Controller (iBMC) of the servers.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Indicator Commands

Indicator Commands

Querying Server Indicator Status (ledinfo)

Function

The ledinfo command is used to query indicator status of the server.

Format

ipmcget -d ledinfo

Parameters

None

Usage Guidelines

None

Example

# Query indicator status.

iBMC:/->ipmcget -d ledinfo
LED Name               : SysHealLed
LED Mode               : Local Control
LED State              : ON
LED Color              : GREEN
LED Color Capabilities : RED GREEN
Default LED Color in
      Local Control    : GREEN
      Override State   : GREEN

LED Name               : UIDLed
LED Mode               : Local Control
LED State              : OFF
LED Color              : BLUE
LED Color Capabilities : BLUE
Default LED Color in
      Local Control    : BLUE
      Override State   : BLUE

Setting the UID Indicator (identify)

Function

The identify command is used to set the UID indicator.

Format

ipmcset -d identify [ -v {time | force }]

Parameters

Parameter Description Value
time Specifies the time (in seconds) for which the UID indicator blinks.

Value range: 0 to 255

The value 0 indicates that the UID indicator is off.

force Forces the UID indicator to be steady on. -

Usage Guidelines

If time is not set, the UID indicator blinks for 15 seconds by default.

Example

# Turn on the UID indicator permanently.

iBMC:/->ipmcset -d identify -v force
Identify UID led successfully.

Setting the Disk Locate Indicator Status (locate)

Function

The locate command is used to set the status of the locate indicator on a hard disk.

Format

ipmcset -d locate -v <ID> <Action>

Parameters

Parameter

Description

Value

ID

Specifies the ID of the hard disk.

Value range: 0 to 255
Action

Specifies the locate indicator status.

  • start: turns on the locate indicator.
  • stop: turns off the locate indicator.

Usage Guidelines

Before running this command, ensure that the following conditions are met:

  • The hard disk is managed by a RAID controller card.
  • The RAID controller card supports iBMC out-of-band management. You can refer to the Technical Specifications section in the RAID controller card user guide to determined whether the RAID card supports the iBMC out-of-band management.
  • The BIOS has started.

If Action is set to start, the locate indicator will continuously blink.

Example

# Turn on the locate indicator on hard disk 5.

iBMC:/->ipmcset -d locate -v 5 start
start locating physical drive (ID:5) successfully
Translation
Download
Updated: 2019-08-01

Document ID: EDOC1000058833

Views: 219980

Downloads: 1936

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next