Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Does an AC Fail to Report Authorized APs After Calibration Is Enabled?
The possible causes are:
- The AC is not configured with an AC ID or carrier ID. In versions earlier than V200R006, configure an AC ID and carrier ID for the AC and commit the configuration. In V200R006 and later versions, the configuration model is optimized and does not include any AC ID and carrier ID. From V200R011C10, configurations are automatically delivered by the switch, without the need to run the commit command.
- The AC does not send neighbor detection messages to APs, APs do not report detected neighbor information to the AC, or errors occur when the AC is saving received neighbor information.