Checking the Indicator Status
Check Criteria
The following table lists the normal indicator states on ACs and APs.
Category |
Indicator |
Normal State |
|---|---|---|
AC |
PWR |
Steady green (If there are two indicators, at least one of them is steady green.) |
SYS |
Slow blinking green |
|
STAT |
Steady green |
|
SPED |
Off |
|
PoE |
Off (Ignore it if the device does not have the PoE indicator.) |
|
Service port indicator |
With a network cable connected: steady green Without a network cable connected: off |
|
AP |
SYS |
Slow blinking green |
Link/ACT |
Steady green or blinking (Ignore it if the device does not have the Link/ACT indicator.) |
|
Wireless |
Blinking yellow green or steady on (Ignore it if the device does not have the Wireless indicator.) |
Procedure
- Observe indicators on each AC and AP.
If all indicators on an AP are off, the indicators may have been turned off through the configuration. It is recommended that you run the undo led off command on the AC to turn on the indicators and then check the indicator status.
- If you find any indicator in an abnormal state, record the fault information immediately and take measures based on the meaning of the indicator state described in the Product Description of the specific product.
- If the fault cannot be rectified, contact your agent or Huawei global service hotline.
