Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
In a VRRP HSB Scenario, When the Master AC Is Restarted, an Active/Standby Switchover Is Triggered Normally. After the Original Master AC Is Restarted, All APs Become Faulty and Services Are Interrupted. Why?
Run the vrrp recover-delay delay-value command on the master AC. If this command is not used, two masters may exist when the original master AC is restarted after an active/standby switchover. In this case, APs enter the Fault state.