Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure an AP to Go Online Using a Static IP Address?
After logging in to an AP, configure it as follows:
- Configure the login mode of the AP.
[Huawei] ap-address mode static
- Configure the IP address and gateway address for the AP to go online in static mode.
[Huawei] ap-address static ip-address 10.23.100.100 24 10.23.100.1
- (Optional) Configure the IP address of the AC. For Layer 2 networking, the AC's IP address is not mandatory. For Layer 3 networking, the AC's IP address is mandatory.
[Huawei]ap-address static ac-list 10.23.100.1
- After an AP is configured to go online using a static IP address, the configuration takes effect only after the AP is restarted.
- When configuring a static IP address, you can configure the gateway address or not.
- A maximum of four IP addresses can be configured for an AC at the same time. The IP addresses are separated by spaces.
- You can run the display ap-address-info command to query the configuration result.
- An AP can go online through the serial port or Telnet.