Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Radio Management FAQs
- Why Does a Manually Configured Radio Channel Not Take Effect?
- What Is Load Balancing? Do APs Support Load Balancing Based on the Number of Users? (If One AP Has More Users Than Another AP in an Area, Can Users Be Evenly Distributed Between the Two APs?)
- What Are the Requirements for a Radio to Join a Load Balancing Group?
- Why Is Displayed Radio Member Traffic Information Inaccurate?
- Do Channel and Power Changes Cause Service Interruption on STAs During Automatic Radio Calibration?
- Why Does an AC Fail to Report Unauthorized APs After Calibration Is Enabled?
- Why Cannot Authorized Neighbors Be Detected After Radio Calibration Is Enabled?
- Can APs Automatically Select Channels with Higher Quality? Can They Change Channels When Current Channels Encounter Interference from an Electromagnetic Wave Source such as a Microwave Oven?
- Can Spectrum Be Analyzed? If Yes, How Can I Analyze It?
- Why Is No Data Displayed After the AP Spectrum Graph Is Opened on eSight?
- Do APs Support Power Adjustment and What Is the Power Adjustment Mechanism?
- How Does an AP Adjust the Rate?
- Can Huawei 802.11n APs Automatically Switch Between 2.4 GHz and 5 GHz?
- Can Antennas in an Antenna Group on APs That Support MIMO Technology Be Used Independently?
- Do Huawei APs Support Automatic Power Adjustment? How Do They Implement It? Why Cannot Automatic Power Adjustment Implement High-Density Access?
- What Is the AP Bandwidth When an AP Does Not Use the MIMO Antenna?
- What Is the Minimum Adjustment Value of Radio Power for Huawei APs?
- Why Is the RU Channel Utilization 0 on the AC or Central AP?
- What Is the Capacity of nxn MIMO?
- How Can the Uplink/Downlink Signal Power Be Improved by Increasing the AP Antenna Gain?
- How Do I Query the Power of an AP on an AC?
- How Does an AP Adjust the Rate?
- What Can I Do If an AP Cannot Detect Radar Signals?
- What Is EIRP?
- What Are Radar Channels? How Do They Affect Other Channels?
- How Does a STA Synchronize the Channel When the Associated AP Switches to Another Channel?
- Does an AP Listen to and Send Frames over One Channel?
- What Are the Differences Between H20 and H40, How Is the 11n 40 MHz Channel Is Partitioned, and What Are the Meanings of Plus and Minus?
- What Are MIMO, MRC, Beamforming, STBC, and Spatial Multiplexing?
- What Is the Working Process of 802.11n Short GI?