Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Does an AC Fail to Report Unauthorized APs After Calibration Is Enabled?
The possible causes are:
- Unauthorized AP detection is not enabled when calibration is enabled on the AC.
- After the calibration command is executed, the AC does not send neighbor detection messages to APs.
- APs do not receive neighbor detection messages from the AC.
- APs are not enabled to detect neighbors.
- APs do not report detected information to the AC.
- The AC does not receive neighbor information sent from APs.
- Errors occur when the AC is saving received neighbor information.