No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

MA5600T, MA5603T, and MA5608T Hardware Description 25

This manual describes the Huawei MA5600T, MA5603T, and MA5608T hardware specifications, such as dimensions, weight, power consumption, capacity, structure, chassis, slots, boards, power modules, and optical modules.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration (MA5600T ETSI subrack)

Configuration (MA5600T ETSI subrack)

The N63E-22 cabinet adopts the DC power. This topic describes the MA5600T ETSI subrack configuration of the N63E-22 cabinet, and lists the maximum number of subscribers of the cabinet.

The N63E-22 cabinet has the following configurations:

  • Configuration of one ETSI subrack
  • Configuration of two ETSI subracks
  • Configuration of one ETSI subrack and one SPL subrack
  • Configuration of the OLT and OLS

Configuration of One ETSI Subrack

Figure 1-3  Configuration of the N63E-22 cabinet installed with one ETSI subrack

NOTE:
  • The filled holes are for floating nuts to fasten subracks.
  • For the I-type or C3-type PDU, use installation holes 79 and 82; for the B-type PDU, use installation holes 79 and 81.
  • The cabinet can also support an additional service subrack. In this case, it is recommended that the air deflector (if not configured) be configured.

Configuration of Two ETSI Subracks

Figure 1-4  Configuration of the N63E-22 cabinet installed with two ETSI subracks

NOTE:
  • The filled holes are for floating nuts to fasten subracks.
  • For the I-type or C3-type PDU, use installation holes 79 and 82; for the B-type PDU, use installation holes 79 and 81.
  • The air deflector is included in the standard configuration.

Configuration of One ETSI Subrack and One SPL Subrack

Figure 1-5  Configuration of the N63E-22 cabinet installed with one ETSI subrack and one SPL subrack

NOTE:
  • The filled holes are for floating nuts to fasten subracks.
  • For the I-type or C3-type PDU, use installation holes 79 and 82; for the B-type PDU, use installation holes 79 and 81.
Download
Updated: 2019-03-18

Document ID: EDOC1000060621

Views: 137871

Downloads: 3405

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next