No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

MA5600T, MA5603T, and MA5608T Hardware Description 25

This manual describes the Huawei MA5600T, MA5603T, and MA5608T hardware specifications, such as dimensions, weight, power consumption, capacity, structure, chassis, slots, boards, power modules, and optical modules.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
H801GICK Board Description

H801GICK Board Description

The H801GICK board is a 2-port GE optical interface card, providing two upstream or cascading GE optical ports, and it supports the 1588V2 clock signal.

Functional Specifications

Please refer to "Upstream Interface Board Comparison".

Technical Specifications

Please refer to "Power Consumption and Maximum Frame Size of Boards".

Working Principle

Figure 3-29  Working principle of the H801GICK board

The basic working principle of the H801GICK board is as follows:

  • The control module loads the board software, controls the running of the software, and manages the entire board.
  • The electronic switch module switches the service signals during the active/standby switchover.
  • The Ethernet network physical layer module provides the GE port for extracting the physical layer packets.
  • The power module supplies power to other functional modules of the board.
  • The clock module provides clock signals for other functional modules of the board.

Front Panel Port



For details about supported optical module, see GE Optical/Electrical Module.

NOTE:
If ports on the H801GICK board is used with the electrical module, the restrictions are as follows:
  • In forced mode, only 1000 Mbit/s and full-duplex are supported, and other rates and duplex modes are not supported.
  • In autonegotiation mode, only 1000 Mbit/s and full-duplex are supported, and other rates and duplex modes are not supported.

Indicator

Indicator

Name

Color

Status

Meaning

RUN

Running status indicator

Green

Blinking slowly (on for 1 s and off for 1 s repeatedly)

The board functions properly

Green

Blinking quickly (on for 0.25 s and off for 0.25 s repeatedly)

The board starts up and is being loaded with software

-

Off

The board is faulty

ALM

Alarm indicator

Red

On

The board is faulty or its CPLD software is being updated

-

Off

The board functions properly

LINK

Link status indicator

Green

On

The link is normal

-

Off

The link is abnormal

ACT

Data status indicator

Yellow

Blinking

Data is being transmitted

-

Off

No data is being transmitted

Download
Updated: 2019-03-18

Document ID: EDOC1000060621

Views: 135918

Downloads: 3372

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next