No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


MA5600T, MA5603T, and MA5608T Hardware Description 25

This manual describes the Huawei MA5600T, MA5603T, and MA5608T hardware specifications, such as dimensions, weight, power consumption, capacity, structure, chassis, slots, boards, power modules, and optical modules.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
H802OPGE Board Description

H802OPGE Board Description

The H802OPGE board is a 48-port GE/FE Optical interface board, providing Ethernet optical access and cascading. It supports up to 48 channels of GE/FE P2P access services.

Functional Specifications

Please refer to "P2P Interface Board Comparison".

When you use H802OPGE boards to replace H802OPGD boards that are bound together, pay attention to the following items:

  • For V800R013C00 or earlier versions, you need to remove the 2 H802OPGD boards that are bound together and then replace them with H802OPGE boards. Note that the H802OPGD board and the H802OPGE board cannot be installed in the 2 slots (that are bound together) at the same time.
  • For V800R013C10 or later versions, you need to remove one of the 2 H802OPGD boards (that are bound together) and then install 1 H802OPGE board. After the H802OPGE board starts up and functions normally, replace another H802OPGD board.

Technical Specifications

Please refer to "Power Consumption and Maximum Frame Size of Boards".

Working Principle

Figure 3-78  Working principle of the H802OPGE board

The basic working principle of the H802OPGE board is as follows:
  • The control module controls the board software loading and board running, and manages the board.
  • The interface module transmits and receives signals.
  • The service processing module processes Ethernet packets, processes and forwards service data packets, and implements service flow management.
  • The power module supplies power to each functional module of the board.
  • The clock module provides the working clock for each functional module of the board, and supports synchronous clock issuing.

Front Panel Port

For details about supported optical module or electrical module, see GE Optical/Electrical Module, FE Optical Module, and FE/GE Adaptive Optical Module.


The LC optical connector used in H802OPGE is shorter than the average LC optical connector.








Running status indicator



The board enters the APP start phase during the board startup


Blinking quickly (on for 0.25 s and off for 0.25 s repeatedly)

The board enters the phase of communication with the control board during its startup


Blinking slowly (on for 1 s and off for 1 s repeatedly)

The board works in the normal state



A high-temperature alarm is generated



The board is faulty


Only LEDs with the even IDs are valid when the port is connected to a one-channel optical module.

Link status indicator



The connection is successful



The connection fails



Data is being transmitted

Updated: 2019-03-18

Document ID: EDOC1000060621

Views: 152709

Downloads: 3512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next