No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Specify Files for Next Startup?

How Do I Specify Files for Next Startup?

Files for next startup include system software, configuration files, and patch files. Commands for specifying files for next startup vary depending on the file type:

  • To specify as the system software for next startup, run:
    <HUAWEI> startup system-software
  • To specify vrpcfg.cfg as the configuration file for next startup, run:
    <HUAWEI> startup saved-configuration vrpcfg.cfg

    After specifying the configuration file for next startup, do not save the current configuration when using the reboot command to restart the device. When the following message is displayed, enter N:

    Warning: The current configuration will be saved to the next startup saved-configuration file. Continue? [Y/N]: N

    Alternatively, run the copy source-filename startup destination-filename [ slot slot-id | all ] command to copy the configuration file and set the file copy as the configuration file for next startup. This command has been supported since V200R005C00.

    CE12800 and CE12800E series switches do not support slot slot-id and all parameters.

  • To specify patch.pat as the patch file for next startup, run the following command. In the command, all indicates all cards or stack member switches).
    <HUAWEI> startup patch patch.pat all
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 604659

Downloads: 2938

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next