No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Should I Do If the Device Reports the Repeater failed Hardware Alarm?

What Should I Do If the Device Reports the Repeater failed Hardware Alarm?

On CE series switches, you can run the display device alarm hardware command to view hardware alarm information on the device. If "The board partially failed" is displayed in the command output and the possible cause is Repeater failed, the chip is unstable. In this case, you can reset the device and check whether the fault is rectified. If the fault persists, collect alarm, log, and configuration information, and contact technical support personnel.

Translation
Download
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 611723

Downloads: 2956

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next