No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Check the OpenFlow User Policy Entry Information on a CE Switch?

How Do I Check the OpenFlow User Policy Entry Information on a CE Switch?

The OpenFlow user policy table on a CE switch is configured on the Agile Controller and then delivered by the Agile Controller to the CE switch. The OpenFlow user policy entry information includes the priority, protocol type, source IP address, destination IP address, next-hop IP address, and outbound interface. You can run the display openflow flows standard command to view the information.

<HUAWEI> display openflow flows standard
Entry ID: 0
Priority: 123
Match Information:
Protocol: 6
SrcPort : 8080
DstPort : 8080
DSCP : 12
Instruction Information:
Write Actions:
Set DSCP : 30
OutPort : 10GE1/0/1
NextHop :
Fail Action: forward
Table 22-77 Description of the display openflow flows standard command output



Entry ID

User policy entry ID.


User policy entry priority. A larger value indicates a higher priority.

Match Information

User policy entry matching information.


Protocol type.


Source IP address/mask.


Destination IP address/mask.


Source port number.


Destination port number.


DSCP priority.

Instruction Information

Action instruction set. The switch matches packets against user policy entries, and takes actions on the positively matching packets.

Write Actions

Action in the action instruction set.


DSCP priority. The positively matching packets are processed based on DSCP priorities.


Outbound interface number. The positively matching packets are sent out through this interface.


Next-hop IP address. The positively matching packets are sent to this IP address.

Fail Action

Action taken on the positively matching packets upon an execution failure of the action in the instructions, including:
  • forward: forwards the packets based on the routes in the routing table.

  • discard: discards the packets.

Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 607725

Downloads: 2950

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next