No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Which Working Modes Does an Eth-Trunk Support?

Which Working Modes Does an Eth-Trunk Support?

Table 22-62 describes the working modes supported by an Eth-Trunk.

Table 22-62 Working modes of an Eth-Trunk

Link Aggregation Mode

Usage Scenario

Version

Manual load balancing mode

This mode is used when the remote device does not support LACP.

All versions

LACP mode

Static LACP mode

This mode is used when the remote device supports LACP.

The dynamic LACP mode is used only when CE series switches connect to servers. You are advised to deploy the static LACP mode in other scenarios. If the dynamic LACP mode is used in other scenarios, network loops may occur.

All versions

Dynamic LACP mode

V100R003C00 and later versions

By default, an Eth-Trunk works in manual load balancing mode.

Ensure that the local and remote devices use the same Eth-Trunk working mode.

Translation
Download
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 606166

Downloads: 2941

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next