No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Causes

Common Causes

This fault commonly results from one of the following causes:

  • The incoming interface is not enabled with RIP.

  • The incoming interface is not in Up state.

  • The version number sent by the peer does not match that received on the local interface.

    RIP version 2 broadcast receives all packets from the peer.

  • The undo rip input command is configured on the interface so the interface is disabled to receive the RIP packet.

  • The policy that is used to filter the received RIP routes is configured.

  • The metric of the received routes is larger than 16.

  • Other protocols learning the same routes in the routing table.

  • The number of received routes exceeds the upper limit.

Translation
Download
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 613392

Downloads: 2962

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next