No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can I Add a Stack Member Switch Without Affecting Services?

How Can I Add a Stack Member Switch Without Affecting Services?

To add a member switch to a stack, perform the following operations in sequence:
  1. Upgrade the software version of the new switch to the current stack system version to prevent multiple restarts resulted from version synchronization and speed up stack setup.
  2. Complete the stack configuration of the switch, save the configuration, and then power off the switch.
  3. Connect the switch to the stack using stack cables.
  4. Power on the switch to enable it to join the stack without affecting the stack.
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 608418

Downloads: 2951

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next