No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Is the LACP Mode Configured When a CE Switch Connects to a Third-Party Device Through an Eth-Trunk?

How Is the LACP Mode Configured When a CE Switch Connects to a Third-Party Device Through an Eth-Trunk?

Run the mode { lacp-static | lacp-dynamic | manual [ load-balance ] } command in the Eth-Trunk interface view to configure the LACP mode of the Eth-Trunk on the CE switch.

When a CE switch connects to a third-party device, the LACP modes must be consistent. Mainstream network devices that connect to CE switches include devices from Cisco, Juniper, and H3C. The following table describes the mapping between aggregation modes.
Table 22-63 Mapping between link aggregation modes on a Cisco device and a Huawei device

Working Mode on a Cisco Device

Working Mode on a Huawei Device

on

manual (default mode)

active (LACP)

lacp-static

passive (LACP)

lacp-static

auto (PAgP)

Interworking is not supported.

desirable (PAgP)

Interworking is not supported.

Table 22-64 Mapping between link aggregation modes on a Juniper device and a Huawei device

Working Mode on a Juniper Device

Working Mode on a Huawei Device

Manual mode

manual (default mode)

LACP

lacp-static

Table 22-65 Mapping between link aggregation modes on a H3C device and a Huawei device

Working Mode on an H3C Device

Working Mode on a Huawei Device

Static LACP mode

manual (default mode)

LACP

lacp-static

Translation
Download
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 615761

Downloads: 2965

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next