No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Troubleshooting Guide

CloudEngine 16800, 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Can I Directly Connect 10GE Interfaces Converted from 40GE Interfaces?

Can I Directly Connect 10GE Interfaces Converted from 40GE Interfaces?

If you run the port split command to configure two 40GE interfaces at both ends of a link into 10GE interfaces respectively, you can use a flange to connect some converted 10GE interfaces and add the interfaces into an Eth-Trunk to increase the link bandwidth. The other converted 10GE interfaces that are not connected through the flange can be used for other purposes.

For example, split a 40GE interface on a CE7850EI into four 10GE interfaces, and add two converted 10GE interfaces into an Eth-Trunk to provide a bandwidth of 20 Gbit/s.

Figure 22-102 Connecting converted 10GE interfaces through a flange

1. Configure the interface split mode. (Only the CE8850-64CQ-EI, CE7850EI, and CE7855EI support this step.)

<HUAWEI> system-view
[~HUAWEI] port split mode mode2 slot 1  
Warning: This operation may cause the split configurations on the board to be lost. This mode will take effect after board is reset.
 Continue? [Y/N]: y
[*HUAWEI] commit
[~HUAWEI] quit
<HUAWEI> save
<HUAWEI> reset slot 1  

2. Configure interface split.

<HUAWEI> system-view
[~HUAWEI] port split dimension interface 40ge 1/0/1 split-type 4*10GE  
Warning: This operation will cause all the other configurations on the port to be lost, and the configuration will take effect after 
the board is reset. Continue? [Y/N]: y 
[*HUAWEI] commit
[~HUAWEI] quit
<HUAWEI> save
<HUAWEI> reset slot 1  

For device models that support dynamic interface split, see Configuration - Interface Management Configuration Guide - Ethernet Interface Configuration - Configuring Attributes for an Optical Interface - Configuring Interface Split.

3. Create an Eth-Trunk.

<HUAWEI> system-view
[~HUAWEI] interface eth-trunk 2  
[*HUAWEI-Eth-Trunk2] trunkport 40ge 1/0/1:1 to 1/0/1:2   
[*HUAWEI-Eth-Trunk2] commit  
Translation
Download
Updated: 2020-01-07

Document ID: EDOC1000060766

Views: 617087

Downloads: 2967

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next