No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

X6800 Server V100R003 User Guide 13

This document describes the Huawei X6800 server (X6000 for short) in terms of its appearance, features, specifications, system components, device installation, cable connections, and installation verification.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Basic HMM Data

Configuring Basic HMM Data

Scenarios

Configure basic HMM data.

Prerequisites

Conditions

Log in to the HMM CLI.

Data

No data preparation is required for this operation.

Procedure

  1. Configure an HMM IP address.

    NOTICE:

    After the IP address is configured, the new IP address takes effect immediately, and you must use the new IP address to log in again.

    On the HMM CLI, run one of the following commands:
    • Setting an IPv4 address: ipmcset -d ipaddr -v <ipaddr> <mask> [gateway]
    • Setting an IPv6 address: ipmcset -d ipaddr6 -v <ipaddr6/prefixlen> [gateway6]

      Table 4-5 describes the parameters in the ipaddr and ipaddr6 command.

    Table 4-5 Parameter description

    Parameter

    Description

    Value

    ipaddr

    Specifies the IPv4 address of the network port to be configured.

    The value of this parameter is in the data type of IPv4 and in the format of xxx.xxx.xxx.xxx.

    mask

    Specifies the subnet mask of the network port to be configured.

    The value of this parameter is in the data type of IPv4 and in the format of xxx.xxx.xxx.xxx.

    gateway

    Specifies the gateway address of the network port to be configured.

    The value of this parameter is in the data type of IPv4 and in the format of xxx.xxx.xxx.xxx.

    ipaddr6

    Specifies the IPv6 address of the network port to be configured.

    The value is an IPv6 address in the format of xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx. When multiple continuous xxxx are 0, the value is in the format of xxxx::xxxx. For example, 2001:0000:000:0000:0000:0000:0000:0001 can be written as 2001::0001.

    An IPv6 address can contain only one xxxx::xxxx.

    prefixlen

    Specifies the subnet prefix length of the network port to be configured.

    0 to 128.

    gateway6

    Specifies the IPv6 gateway address of the network port to be configured.

    The value is an IPv6 address in the format of xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx. When multiple continuous xxxx are 0, the value is in the format of xxxx::xxxx. For example, 2001:0000:000:0000:0000:0000:0000:0001 can be written as 2001::0001.

    An IPv6 address can contain only one xxxx::xxxx.

  2. Configure other basic HMM data.

    For details about how to configure other basic data for the HMM, see the X6800 Server HMM Command Reference.

Translation
Download
Updated: 2018-09-06

Document ID: EDOC1000066339

Views: 29862

Downloads: 1686

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next