No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

X6800 Server Node iBMC (Earlier Than V250) User Guide 29

This document describes the underlying management software Intelligent Baseboard Management Controller (iBMC) of the servers.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Server Over a Network Port by Using the PuTTY

Logging In to the Server Over a Network Port by Using the PuTTY

Scenarios

Using the PuTTY, you can remotely log in to the server over a local area network (LAN) and to configure and maintain the server.

Prerequisites

Conditions

The PC is connected to the management network port of the server over a network cable.

Data

The following information must be prepared:
  • IP address of the server to be connected
  • User name and password for logging in to the server to be connected

Software

PuTTy.exe: a piece of free software. You can download it by yourself.

Procedure

    1. Set an IP address and a subnet mask or add route information for the PC, and ensure that the PC can properly communicate with the server.

      You can run the Ping Server IP address command on the PC command-line interface (CLI) to check the communication between the PC and the server.

    2. Double-click PuTTY.exe.

      The PuTTY Configuration window is displayed, as shown in Figure 5-27.

      Figure 5-27 PuTTY Configuration window

    3. Set login parameters.

      The following describes the parameters:
      • Host Name (or IP address): Enter the IP address of the server to be logged in to. For example, 191.100.34.32.
      • Port: Retain the default value 22.
      • Connection type: Retain the default value SSH.
      • Close window on exit: Retain the default value Only on clean exit.
      NOTE:

      Configure Host Name and Saved Sessions, and click Save. In the future use, double-click the saved record in Saved Sessions to log in to the server.

    4. Click Open.

      The PuTTY window and login as: are displayed, waiting you to enter a user name.

      NOTE:
      • If you log in to the target server for the first time, the PuTTY Security Alert window is displayed. If you trust this site, click Yes. Then the PuTTY window is displayed.
      • If the entered user name is incorrect during server login, the PuTTY must be connected to again.

    5. Enter a user name and password by following instructions.

      After login, the server host name is displayed on the left of the prompt.

Translation
Download
Updated: 2019-02-28

Document ID: EDOC1000066341

Views: 132694

Downloads: 1081

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next