No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro X6800 Server iBMC (Earlier Than V250) User Guide 31

This document describes the underlying management software Intelligent Baseboard Management Controller (iBMC) of the servers.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Trap on the iBMC WebUI

Configuring Trap on the iBMC WebUI

Scenarios

Enable the trap function on Alarm & SEL > Alarm Setting of the iBMC WebUI.

The trap function enables the iBMC to send alarm information, event information, and trap properties to a third-party server through trap messages.

Prerequisites

Data

  • SNMP trap version
  • Host identifier (such as Board Serial Number, Product Asset Tag, or Host Name) used to identify the source of the message
  • SNMP trap community name
  • Address of the server receiving trap messages

Procedure

  1. Log in to the iBMC WebUI.
  2. Choose Alarm & SEL > Alarm Setting.
  3. In the Trap Alarm Notification Settings area, set Trap Function to .
  4. Set trap parameters and click Save.

    Set the following parameters:

    • Trap Version: Select an SNMP trap version. SNMPv3 is recommended.

      Exercise caution when using SNMPv1 and SNMPv2c, because they pose security risks.

    • Choose Trap V3 User: Set this parameter only when Trap Version is SNMPv3. The default user is root.
    • Trap Mode: Set the mode for report trap information.

      • Select OID to use the object identifier of the SNMP node to identify a trap event.
      • Select Event Code to use the event code to identify a trap event.
    • Trap Server Identity: Set the source host of the trap message. The source host can be identified by Board Serial Number, Product Asset Tag, or Host Name.
    • Community Name and Confirm Community Name: Set the community name only when Trap Version is set to SNMPv1 or SNMPv2c. The community name is used for trap authentication if SNMPv1 or SNMPv2c is used. Community Name and Confirm Community Name must be the same.
    • Set Alarm Severities: Select the severities of alarms to be reported through trap messages.

  5. Set the trap server and message format.

    A maximum of four channels can be specified to send alarms.

    1. Click under the Operation column of a channel.
    2. Set Current Status to .
    3. In Trap Server IP Address, enter an IPv4 or IPv6 address for the server that receives the trap messages.
    4. In Trap Port, enter the port number. The default port number is 162.
    5. Select the delimiter used to separate the key words in trap messages.
    6. In Select Message Content, select the content to be included in trap messages. The content includes time, sensor name, severity, event code, and event description.
    7. Select Display Keyword in Message to display the keywords in trap messages. Deselect this check box if you do not want to display the keywords in trap messages.

    8. Click Save.

      If "Operation successful" is displayed, the configuration is saved successfully.

    9. Click Test to check whether the trap channel is available.

      If "Operation successful" is displayed, the trap channel is available.

Translation
Download
Updated: 2019-08-01

Document ID: EDOC1000066341

Views: 180657

Downloads: 1092

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next