No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

X6800 Server Node iBMC (Earlier Than V250) User Guide 30

This document describes the underlying management software Intelligent Baseboard Management Controller (iBMC) of the servers.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server over a Serial Port Using PuTTY

Logging In to a Server over a Serial Port Using PuTTY

Scenarios

Use PuTTY to log in to a server over a serial port in any of the following scenarios:
  • The server is configured for the first time at a site.
  • A remote connection to the server cannot be established.

Prerequisites

Conditions

  • The local PC is connected to the server through a serial cable.
  • PuTTY 0.60 or later is installed.

Data

  • IP address of the server
  • User name and password for logging in to the server

Software

PuTTY, free software available at the chiark website.
NOTE:

The PuTTY of the latest version is recommended, because an earlier version may cause a failure in accessing the storage system.

Procedure

    1. Double-click PuTTY.exe.

      The PuTTY Configuration window is displayed.

    2. In the navigation tree, choose Connection > Serial.
    3. Set the login parameters.

      Example:
      • Serial line to connect to: COM1
      • Speed (baud): 115200
      • Data bits: 8
      • Stop bits: 1
      • Parity: None
      • Flow control: None

    4. In the navigation tree, choose Session.
    5. Select Serial under Connection type, as shown in Figure 4-29.

      Figure 4-29 PuTTY Configuration window

    1. Click Open.

      The PuTTY login window is displayed.

    2. Enter the user name and password.

      If the login is successful, the server host name is displayed on the left of the prompt.

Translation
Download
Updated: 2019-06-04

Document ID: EDOC1000066341

Views: 147828

Downloads: 1083

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next