No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

X6800 Server Node iBMC (Earlier Than V250) User Guide 29

This document describes the underlying management software Intelligent Baseboard Management Controller (iBMC) of the servers.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Running the ifconfig Command (ifconfig)

Running the ifconfig Command (ifconfig)

Function

The ifconfig command is used to run the ifconfig command in Linux.

Format

For details, refer to the syntax of the ifconfig command in Linux.

Parameters

This command supports only the lo, ethn (n indicates a network port index number), or -a parameter, or no parameter.

Usage Guidelines

None

Example

iBMC:/->ifconfig eth1                                                       
eth1      Link encap:Ethernet  HWaddr 00:18:82:11:03:21   
          inet6 addr: fe80::218:82ff:fe11:321/64 Scope:Link 
          UP BROADCAST DEBUG RUNNING  MTU:1500  Metric:1 
          RX packets:28 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:37 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:1832 (1.7 KiB)  TX bytes:2558 (2.4 KiB) 
          Interrupt:28 
Translation
Download
Updated: 2019-02-28

Document ID: EDOC1000066341

Views: 133208

Downloads: 1081

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next