No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSpace 8950 IP Phone V200R003C00 Administrator Guide

Provides information about deployment, operate and maintain the Video Phone.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Phone IP Address

Configuring the Phone IP Address

This section describes how to configure the phone IP address on the eSpace 8950 LCD screen.

DHCP

By default, DHCP mode is selected. This allows eSpace 8950 to obtain an IP address from the DHCP server.

To enable DHCP on an IPv4 network, perform the following steps:

  1. Tap and choose APPLICATIONS > Settings
  2. Choose Ethernet > IPv4.
  3. Choose IPv4 Settings > DHCP and press OK.

Static IP

If a static IP address is required for eSpace 8950, set IPv4 Settings to Static.

Obtain an IP address, subnet mask, gateway address, and DNS address from your network administrator. To set a static IP address for eSpace 8950, perform the following steps:

  1. Tap and choose APPLICATIONS > Settings
  2. Choose Ethernet > IPv4.
  3. Choose IPv4 Settings > Static.
  4. Set IP, Gateway, Subnet Mask, and DNS Server, and press OK.

    NOTICE:
    • The IP phone and USB camera communicate with each other using IP addresses 172.31.255.253 and 172.31.255.254. It is not allowed to set the external IP address of the IP phone to 172.31.255.253 or 172.31.255.254; otherwise, an IP conflict will occur.
    • The communication ports for the USB camera are TCP and RTP ports. The USB camera uses these ports for communicating with only the IP phone, but not other equipment. The TCP and RTP ports are described as follows:
      • TCP port 6060 is used to transmit commands between the IP phone and the USB camera.
      • RTP port range: 25000-28003, which are used to transmit images between the IP phone and the USB camera.

Translation
Download
Updated: 2018-09-12

Document ID: EDOC1000067158

Views: 47543

Downloads: 1812

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next