No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX110 Switch Module V100R001C10 User Guide 10

This document describes the features, installation, removing, and configuration methods of the CX110 GE switch module of the E9000 server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering On or Off a Switching Plane

Powering On or Off a Switching Plane

This topic describes how to power on or off the GE switching plane of CX110 using the MM910 WebUI.

Use any of the following methods to power on the CX110:

  • Power on all switching planes of the CX110 on the MM910 WebUI. Details are provided later in this topic.
  • On the MM910 CLI, run the powerstate command to power on or off the switching planes of the CX110. For details, see MM910 Management Module V100R001 Command Reference.
  • On the BMC CLI, run the powerstate command to power on or off the switching planes of the CX110. For operation details, see E9000 Server V100R001 iMana 200 User Guide.
  • If the chassis is not powered on, power it on, and all the switching planes of the CX110 will be powered on with the chassis. This topic does not provide the operation details.
  • If the chassis is powered off, the GE switching plane of the CX110 is powered off with the chassis.
  • If the chassis is powered on but the CX110 is not installed, install the CX110, and all switching planes of the CX110 are automatically powered on after installation. This topic does not provide the operation details.
  • If the chassis is powered on and the CX110 is installed, remove the CX110 to power off the GE switching plane.

Impact on the System

After the GE switching plane is powered off, all services that run on the GE switching plane stop.

Prerequisites

Conditions

  • The RS–232 serial port on the PC is connected to the serial port marked with SYS on the CX110 panel.
  • The MM910 is powered on.
  • The current configuration data has been saved.

Data

No data preparation is required for this operation.

Software

PuTTY.exe is free software. You can download it from the Internet. PuTTY 0.60 or later is required for login over a serial port.

Procedure

  1. Connect The RS–232 serial port on the PC to the serial port marked with SYS on the CX110 panel.
  2. Save the current configuration data.
  3. Power on or off switching planes on the MM910 WebUI.

    1. Log in to the MM910 WebUI.

      For details, see Logging In to the MM910 WebUI.

    2. Choose Pem&Fantray.

      The Pem&Fantray page is displayed.

    3. In the navigation tree on the left of the Pem&Fantray page, choose Power Supply Management > Power Control.
      Figure 6-4 Power Control page
    4. Power on or off the GE switching plane of a specific switch module.

      fabric indicates the GE switching plane.

    5. Refresh the page and check the latest power-on and power-off status of the switch module.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000068625

Views: 19666

Downloads: 487

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next