No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CX110 Switch Module V100R001C10 User Guide 10

This document describes the features, installation, removing, and configuration methods of the CX110 GE switch module of the E9000 server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the MM910 CLI Over a Network Port by Using PuTTY

Logging In to the MM910 CLI Over a Network Port by Using PuTTY

This topic describes how to use PuTTY to remotely log in to a server over a local area network (LAN) and to configure and maintain the server.




You have obtained the following data:

  • IP address of the server to be connected
  • User name and password for logging in to the server to be connected


PuTTY.exe: third-party software.


  1. Connect the local PC and the MGMT port on the MM910 through a network cable.
  2. Set an IP address and a subnet mask or add route information for the PC so that the PC can properly communicate with the server.

    You can run the Ping Server IP address command on the PC command-line interface (CLI) to check the communication between the PC and the server.

  3. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed.

  4. In the navigation tree on the left, choose Connection > SSH.
  5. Set the login parameters.

    The parameters are described as follows:

    • Host Name (or IP address): Enter the IP address of the server to be logged in to, for example,
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.

    Set Host Name and Saved Sessions, and click Save. In the future use, double-click the saved record in Saved Sessions to log in to the server.

  6. In the navigation tree, choose Session and select SSH for Connection type.

    Figure 6-1 PuTTY Configuration

  7. (Optional) Choose Terminal > Keyboard, and select Control-Hunder The Backspace key.

    This setting can solve the problem that the characters on the CLI cannot be deleted by using the Backspace key.

    Figure 6-2 PuTTY Configuration

  8. Click Open.

    The PuTTY window and the following information are displayed, waiting for you to enter a user name.
    login as:
    • If this is your first login to the server, the PuTTY Security Alert dialog box is displayed. Click Yes to proceed.
    • If an incorrect user name or password is entered, you must set up a new PuTTY session.

  9. Enter the user name and password.

    If the login is successful, the server host name is displayed on the left of the prompt.

Updated: 2019-08-09

Document ID: EDOC1000068625

Views: 19699

Downloads: 487

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next