No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CX110 Switch Module V100R001C10 User Guide 10

This document describes the features, installation, removing, and configuration methods of the CX110 GE switch module of the E9000 server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the CX110

Removing the CX110

To replace a switch module, see section "Replacing a Switch Module" in the E9000 Server V100R001 User Guide.

Impact on the System

After the switch module is removed, all services running on the switch module stop.



The following tools are available:

  • Protective gloves
  • Electrostatic discharge (ESD) gloves
  • Phillips screwdriver (PH2 is 6 mm or 0.25 in.)


Figure 3-9 Removal process


  1. Determine the CX110 to be removed.

    Figure 3-10 shows the slot numbers.
    Figure 3-10 Slot numbers

  2. Determine the connection relationships between signal cables and ports on the CX110. Figure 3-11 shows the port types and numbers of the CX110.

    Figure 3-11 Port types and numbers


    BMC serial port


    GE electrical port


    10GE optical port


    SYS serial port

  3. (Optional) Remove a GE cable or serial cable.

    Figure 3-12 Removing a GE cable or serial cable

    The BMC serial port, SYS serial port, and GE electrical port are standard RJ-45 ports and are disconnected in the same way.

  4. Remove a 10GE optical fiber and optical module.

    1. Remove the optical fiber from the optical module. See (1) and (2) in Figure 3-13.
    2. Install the dust-proof cap for the optical module. See (3) in Figure 3-13.
      Figure 3-13 Removing an optical fiber
    3. Determine the optical module type and removal position based on site requirements.
    4. Remove the optical module horizontally from the optical port, as shown in Figure 3-14.
      Figure 3-14 Removing an optical module

  5. Remove the CX110.

    1. Use a Phillips screwdriver to loosen the two M3 captive screws. See (1) in Figure 3-15.
      Figure 3-15 Removing the switch module
    2. Raise the two ejector levers on the CX110 completely and pull the switch module horizontally out of the chassis. See (2) and (3) in Figure 3-15.
    3. Lower the ejector levers on the CX110. See (4) in Figure 3-15.

      An ESD bag holds only one switch module.

    4. Place the removed switch module into an ESD bag.

  6. Install a switch module filler panel.

    1. Raise the two handles on the switch module filler panel and push the filler panel horizontally into the chassis as far as it will go. See (1) in Figure 3-16.
      Figure 3-16 Installing a switch module filler panel
    2. Lower the two handles on the switch module filler panel. See (2) in Figure 3-16.
    3. Use a Phillips screwdriver to tighten the two M3 captive screws on the switch module filler panel. See (3) in Figure 3-16.

Updated: 2019-08-09

Document ID: EDOC1000068625

Views: 18667

Downloads: 487

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next