No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Tools 2.0 uMate User Guide 36

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Viewing MM910 SNMP Protocols

Viewing MM910 SNMP Protocols

Scenarios

View the MM910 SNMP protocols on the HMM WebUI. In this topic, Internet Explorer 11 is used as an example.

Prerequisites

Conditions

The IP address of the local computer and the IP address of the server MM910 management network port are on the same network segment.

If you want to connect your local PC directly to the MM910 using a network cable but the MGMT port on the active MM910 is already connected with a network cable, do not remove the network cable from the MGMT port on the active MM910. Otherwise, an active/standby switchover of the MM910s will be triggered, which may cause network interruption. You can connect the network cable from the local PC to the STACK port of the active MM910 in the chassis. If the STACK port on the active MM910 is also used, connect the network cable to an idle STACK port on an active MM910 in a chassis cascaded with the E9000 chassis.

Data

You have obtained the following data:

  • IP address and subnet mask for the MM910 management network port. The IP address indicates only the IPv4 address.
  • User name and password for logging in to MM910

Procedure

  1. Open Internet Explorer, enter the IP address of the MM910 management network port in the address box, and press Enter.

    The address format is http://IP address of the MM910 management network port.

    The security alert dialog box is displayed.

  2. Click Continue to this website (not recommended).

    The login page is displayed, as shown in Figure 5-20.

    Figure 5-20 HMM login page

  3. On the login page, set the parameters as follows:

    1. Select a language.
    2. Enter the user name.
    3. Enter the password.
    4. Select This Machine from the Log on to drop-down list.
    5. Click Log In.

    The HMM management page is displayed, as shown in Figure 5-21.

    Figure 5-21 HMM WebUI

  4. Choose System Management > System Settings > Security Policy.

    The security policy page is displayed. You can view the MM910 SNMP protocols, as shown in Figure 5-22.

    Figure 5-22 Security policy page

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000068881

Views: 65356

Downloads: 4915

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next