No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

CX710 Switch Module V100R001 User Guide 12

This document describes the CX710 40GE converged switch module of the E9000 server in terms of its features, installation, removal, and configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Switching Plane

Checking the Switching Plane

Check the 40GE converged switching plane operating status of the CX710 and ensure that the 40GE converged switching plane meets the basic requirements of data configuration.


  1. log in to the 40GE converged switching plane CLI.
  2. Run the following command on the CLI of the 40GE converged switching plane to check the current version of the 40GE converged switching plane:

    <HUAWEI> display version

    The command output is as follows:

    Huawei Versatile Routing Platform Software 
    VRP (R) software, Version 8.80 (OSCA V100R003C03) 
    Copyright (C) 2012-2014 Huawei Technologies Co., Ltd. 
    HUAWEI OSCA uptime is 0 day, 22 hours, 37 minutes 
    CX710(Master) 3 : uptime is  0 day, 22 hours, 36 minutes 
            StartupTime 2014/08/08 12:24:34 
    Memory      Size    : 2048 M bytes 
    Flash       Size    : 1024 M bytes 
    CX710 version information 
    1. PCB      Version : CX710 VER A 
    2. MAB      Version : 0 
    3. Board    Type    : CX710 
    4. CPLD    Version : 0.02 
    5. BIOS     Version : 2.43 
    6. Software Version : 3.02

    Software Version indicates the current software version.

  3. Check whether the software version is consistent with the desired one.

    • If yes, go to 4.
    • If no, contact Huawei technical support.

  4. Query the alarms of the 40GE converged switching plane.

    <HUAWEI> display alarm active

    The command output is as follows:

    1:Critical  2:Major  3: Minor  4:Warning 
    Sequence AlarmId    Level Date Time  Description                 

    The parameters are described as follows:

    • Critical: critical alarm
    • Major: major alarm
    • Minor: minor alarm
    • Warning: warning alarm
    • Sequence: alarm sequence
    • AlarmId: alarm ID
    • Level: alarm severity
    • Date Time: date and time at which an alarm is generated
    • Description: alarm description

      If no information is displayed, no alarm is generated.

  5. Check whether an alarm is generated.

    • If yes, go to 6.
    • If no, no further action is required.

  6. Handle the alarm. For details, see the E9000 Server V100R001 Alarm Handling.
Updated: 2019-12-04

Document ID: EDOC1000069172

Views: 32140

Downloads: 463

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next