Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Network Management
In ESXi, configure an Ethernet port as the management network port and install the VMware vSphere Client on the PC to manage system services.
- On the ESXi main screen, press F2, and enter the user name and password. The System Customization page is displayed, as shown in Figure 5-5.
- Choose Configure Management Network and press Enter. On the Network Adapters page, select a management network port using the Space bar, and press Enter. See Figure 5-6.
- On the IP Configuration screen, select Use dynamic IP address and network configuration to dynamically assign an IP address over DHCP; or select Set static IP address and network configuration, and set IP Address, Subnet Mask, and Default Gateway. Then press Enter. See Figure 5-7.
- Press Esc. On the displayed screen, enter Y. See Figure 5-8.
- Check that the IP address information is displayed on the right of the screen. See Figure 5-9.
- Run the VMware vSphere Client. After logging in to the tool, you can manage system services.
