No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 Series Agile Switches OSP Quick Start Quide

This document describes hardware installation and basic configuration of the OSP card.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the OSP Card in the Switch

Installing the OSP Card in the Switch

Context

  • Before installing an OSP card into a slot, remove the filler panel from the slot.
  • Wear an ESD wrist strap or a pair of ESD gloves when you install the card. Do not touch the card with bare hands.
  • When installing an OSP card, push the card slowly and horizontally into the slot along guide rails to protect components on the cards from collisions.
  • Do not touch the electronic devices on the card during the installation.
  • Cover all the vacant slots with filler panels to ensure good electromagnetic shielding, heat dissipation, and dustproof performance.

Tools

ESD wrist strap or ESD gloves

Procedure

  1. Wear an ESD wrist strap and insert the other end into the ESD jack on the cabinet, or wear ESD gloves.
  2. Remove the card to be replaced or filler panel on the slot.
    1. Release the locks on the ejector levers at both sides of the card, and then open the ejector levels to eject the card from the connector on the backplane. See callout 1 in Figure 2-4.
    2. Grasp the ejector levers and pull out the card slowly along with the guide rails. See callout 2 in Figure 2-4.

    Figure 2-4  Removing a filler panel

    NOTE:

    Keep the removed filler panel in an appropriate place for later use.

  3. Install the OSP card.
    1. Slowly push the card into the slot until the card is securely connected to the backplane. See callout 1 in Figure 2-5.
    2. Rotate the ejector levers inwards to secure the card. See callout 2 in Figure 2-5. When you hear a click from the ejector levers, the card is properly installed.

    Figure 2-5  Installing a card into the chassis

  4. Observe the RUN/ALM indicator on the new card.

    • If the RUN/ALM indicator blinks green fast, the card is starting.
    • If the RUN/ALM indicator blinks green slowly, the card is running normally.

Translation
Download
Updated: 2019-02-13

Document ID: EDOC1000069462

Views: 3474

Downloads: 231

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next