No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 Series Agile Switches OSP Quick Start Quide

This document describes hardware installation and basic configuration of the OSP card.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Installing a Hard Disk in an OSP Card

(Optional) Installing a Hard Disk in an OSP Card


Before installing a hard disk in an OSP card's hard disk slot, install the hard disk in the hard disk cage.


If you purchase hard disks for an OSP card from Huawei, the hard disks are installed on the OSP card before delivery. In this case, directly install the OSP card in the switch.


  • ESD wrist strap or ESD gloves

  • Phillips screwdriver


  1. Wear an ESD wrist strap and insert the other end into the ESD jack on the cabinet, or wear ESD gloves.
  2. Take out the OSP card from the package box, inspect the OSP card to make sure that no components on the card are damaged or missing.
  3. Pull out the hard disk cage from a hard disk slot in the OSP card. Hold down the spring clips at both sides of the handle on the hard disk cage to release the hard disk, and at the same time slowly pull the hard disk cage out. See Figure 2-1.

    Figure 2-1  Removing a hard disk cage

  4. Insert the hard disk into the hard disk cage, and then fasten screws on the hard disk with a Phillips screwdriver to secure the hard disk in the hard disk cage. See Figure 2-2.

    Figure 2-2  Installing a hard disk into a hard disk cage

  5. Push the hard disk slowly into the hard disk slot until it is securely seated in the hard disk slot. See Figure 2-3. When you hear a click, the hard disk has been correctly installed.

    Figure 2-3  Installing a hard disk into a hard disk slot

Updated: 2019-02-13

Document ID: EDOC1000069462

Views: 3489

Downloads: 231

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next