No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S2700, S3700, S5700, S6700, S7700, and S9700 Series Switches Typical Configuration Examples

This document provides examples for configuring features in typical usage scenarios.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Interworking Solution

Interworking Solution

Overview

The interworking mode used by a Huawei S series switch to connect to a server with multiple network adapters depends on the binding mode of network adapters. For details, see Interworking Analysis. The following solution uses the Windows server where network adapters are bundled in SLA mode as an example.

Networking Requirements

In Figure 3-68, the Windows server uses static link aggregation to bind multiple network adapters. A Huawei S series switch connects to the server using link aggregation in manual mode to increase link bandwidth and implement redundancy, ensuring data transmission and link reliability.

Figure 3-68  Networking for connecting a Huawei S series switch to a server using link aggregation

Configuration Roadmap

The configuration roadmap is as follows:
  1. Create an Eth-Trunk on the Huawei S series switch and add member interfaces to the Eth-Trunk to implement link aggregation in manual mode.

  2. Implement static link aggregation on the Windows server to bind multiple network adapters.

Procedure

  1. Configure link aggregation in manual mode on the Huawei S series switch.

    <HUAWEI> system-view
    [HUAWEI] sysname Switch
    [Switch] interface eth-trunk 1
    [Switch-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/2
    [Switch-Eth-Trunk1] quit
  2. Configure static link aggregation on the Windows server to bind multiple network adapters. For details, see corresponding software description.

  3. Verify the configuration.

    Run the display eth-trunk [ trunk-id [ interface interface-type interface-number | verbose ] ] command to check the link aggregation configuration on the Huawei S series switch.

Download
Updated: 2019-04-20

Document ID: EDOC1000069520

Views: 733620

Downloads: 30692

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next